Parents of Teenage drivers:

Automobile accidents are the #1 killer of America's teens. The vast majority
of these accidents are the result of poor driving habits. Peer pressure, loud music, showing off, and general carelessness behind the wheel all contribute to these tragedies. Stop worrying about your teen's driving and get V-Count!

Talking about defensive driving skills, setting curfews and other limits certainly have their place. But what about when you're not there? This is when bad things happen to good teens due to inexperience, peer behavior, and other factors beyond
your control. Based on statistics, over speeding is the number one cause of accidents involving inexperienced teenage and even adult drivers. But, now you can set a speed limit and monitor how many times your teen exceeded that speed limit. 

This is accomplished by supplying the unit with the same Vehicle Speed Signal (VSS) used by the vehicle speedometer. In older vehicles, year 1992 or earlier, that do not use an electronically driven speedometer, a special speed sensor installation kit (VSS Installation Manual, RS Installation Manual) is available (see V-Count II Setup, requires PDF reader or view plain web page).

The speed signal supplied to the V-COUNT II is processed by a microprocessor that compares it with a stored calibration value to determine the vehicle speed at any instant of time.

When the maximum speed limit set by the vehicle owner or fleet manager is violated,  a loud warning tone is sounded. This warning tone remains on until the vehicle speed is reduced below the set maximum. The time in seconds of an Over Speed violation before a violation is logged can be set in the range of 1 to 20 seconds. The default setting is 5 seconds. A flashing red light will turn on if the speed violation lasts for longer than the set time. This Over Speed indicator light can only be extinguished by an authorized person entering the 6 digit Security Code.

Each violation that exceeds the set Over Speed violation will cause a speed violation counter to increment up to the maximum count of 99 for each instance of violation.

If the V-COUNT II is disconnected for more than 20 seconds and then re-connected, a red flashing TAMPER light will start flashing.

-------------------------------------------------------------- Product No.: V-Count II VSS -------------------------------------------------------------- Note: For vehicles generating standard VSS pulses only For Non-standard VSS generating vehicles, VSS Interface Cables is sold separately V-Count II, VSS Price:   $ 105.00

----------------------------------------------------------------- Product No.: V-Count II RS Installation ----------------------------------------------------------------- Note: For vehicles built before 1991. V-Count II, RS Price:   $ 185.00

The V-Count II-EL (External Lights) model will indicate conditions of over speeding and/or tampering by the external display of Blue high intensity Light Emitting Diodes for use by speed enforcement authorities. This speed control method is being used by several countries such as Brunei, Singapore, Hong Kong and Malaysia and is a requirement for large trucks, buses, government and commercial vehicles.

-------------------------------------------------------------- Product No.: V-Count II with EL(External Lights) VSS Installation ------------------------------------------------------------- V-Count II EL, VSS Price:   $ 175.00	----------------------------------------------------------------- Product No.: V-Count II with EL(External Lights) RS Installation ----------------------------------------------------------------- V-Count II EL, RS Price:   $ 285.00
ESO Interface Kit Price:   $ 39.00	Note: Shipping cost is flat down to $50. A refund will be made after we determine the actual shipping cost from our location to destination via secure payment method of Paypal.

 

---

Copyright ©2016 Apexs, Inc. All rights reserved.